How to change front springs / front coil springs on NISSAN QASHQAI 1 (J10) [TUTORIAL AUTODOC]

[@autodocuk]

⚠ Attention! The mistake was made in the video at 6:06 minutes. The tightening torque is 168 Nm, not 110 Nm. We are sorry for the inconvenience.

[@KeefeLoke]

Is it a must to change the coil springs when changing shock absorbers?

[@autodocuk]

Thank you for your feedback.Replacement of springs should be made only in case of wear.Best regards,Autodoc!

[@autodocuk]

🛠️ The tools you need to replace front springs:
- combination spanner No. 21
- combination spanner No. 19
- drive socket No. 21
- drive socket No. 19
- drive socket No. 15
- drive socket No. 14
- copper grease
- wire brush
- WD-40 spray
- torque Wrench
- HEX bit No.H6
- wheel impact socket № 21
- hydraulic strut spring compressor
- ratchet wrench

[@christophephilippe1481]

Mines creaking and grinding after being replaced.. any ideas?

[@autodocuk]

It’s difficult to advise anything based on the description, we recommend to contact the car service.

[@luigifiordalisi1933]

110Nm, 168Nm, 93 Nm,..non c'è un video dove il valore di serraggio sia identico e così per altri video. Dove prendete questi valori ? I manuali riportano valori diversi.

[@autodocuk]

Buingiorno. Grazie per il commento.Non esiste un video in cui il valore di serraggio sia identico . Anche i manuali danno valori diversi.